[restoration] L319D - 1958 - Seite 12 - L319-forum.de  

[restoration] L319D - 1958

Bilder und Beschreibungen von Restaurierarbeiten oder auch selbstherstellen von Ersatzteilen oder Werkzeugen. Sowie Tipps und Tricks die das Arbeiten erleichtern
Antworten
Benutzeravatar
sven280
Beiträge: 12
Registriert: 24.04.2017, 14:36
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon sven280 » 07.02.2020, 13:49

Nice work :) :D :D
Mercedes-Benz, mijn passie www.bloggen.be/debaetssven

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 20.02.2020, 22:13

reassembly continues quietly. the front swinging windows and the rear windows are in place ! the rear lights work. I still have to wire the wiper motor and the "flashing - horn contactor" in the center of the steering wheel to finish with the electricity!


we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 23.02.2020, 11:21

and it continues !!!!! many details that take time and I have not necessarily taken everything in picture :scheinheilig: I finally finished the whole elec !!! and everything works!



fitting the front bumper (by the way, I no longer find the rear bumper supports since I moved from the hangar ... :hammer: :Wandhauer: )

Bild

cleaning, and clean with belgom of all the aluminum rods .... it is the longest to do with rods of 3m20 long: :lol:

Bild

installation of the last front and rear window, front door seals, etc ... I managed to recover the seals with silicone WD40, it works well! it starts to look great!

Bild

Bild

Bild

Bild

now I need to find the outer seal and screw caps that are on the rods. it looks very much like those of old caravans ....

Bild
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 29.02.2020, 07:32

Bild
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 25.03.2020, 08:14

Seeing that I was not far away, I went a little to the garage at midday because I was working in the neighborhood :klatsch:

Bild

Bild

but ..... big problem .... i lost the parts to lock the rear door ...... :cry: :cry: :cry: :cry:

Bild

Bild

no idea where it may be .... i flipped the hangar and couldn't get my hands on it ...
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 06.05.2020, 07:05

I fell there on the bottom of the servant under the ratchet key box :scheinheilig:

Bild

Überraschung :lol: :lol: :lol:

Bild

Bild

the parts I was missing for the rear doors 8)


disassembly of a part of the mechanics in order to work quietly to stall the pump when I recover it.


I sent the injection pump for a complete overhaul and the injectors to be redone because badly tared the first time. the bill may sting ...

Bild

it's hard to work on my cars because my garage is 40km away from my house, and in france we still don't have the right to get out except for work or buying food .... so when i work near my garage i take my lunch break there :)
we can't make new with old .... but we try 8)

Benutzeravatar
Robjota
Beiträge: 142
Registriert: 06.08.2017, 15:37
Wohnort: UK

Re: [restoration] L319D - 1958

Beitragvon Robjota » 06.05.2020, 07:33

Heh Jim. That bill might sting but it'll be good to get it running right. Help with the fuel economy and power too!

Rob

Benutzeravatar
DOTROUV
Beiträge: 13
Registriert: 27.05.2018, 21:00

Re: [restoration] L319D - 1958

Beitragvon DOTROUV » 06.05.2020, 08:02

Hey Jim, i live in France too (Grand Est) :( hopefully we can get back out again after next Monday... :( Good work on the 319, Looks beautiful!

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 27.06.2020, 13:56

i received the injection pump from the garage. she's totally new now.

Bild

i install it with 32° before injection time, but he's still smoking a lot :'(



i saw on internet that many OM636 a timed on 30°, so i test it but still smoking .....



i saw on another om636 manual that it's 26° ........... so i tested, and failed again ....



next step is taking compression to see if there's a problem on this side and fix it ... can wait to drive my 319 :Wandhauer: :Wandhauer: :Wandhauer:
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 22.07.2020, 08:10

good and well, we will put the engine out again, open it and resume quietly, there is something that must have screwed up it's not possible ... first drive on the roads, no power, monster smoke, 50 meters further, engine stops, forced to pump the gasole with the maunal pump. in short, nothing goes right :lol: :lol: :lol: i knew i should have taken a benzin engine :mrgreen: :mrgreen:



the accelerator is at his maximum and it doesn't accelerate.

$

this is a no-ended project :scheinheilig: :mrgreen:
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 31.08.2020, 20:51

let's do the work again ! compression are too bad, a friend told me that i must be 19-20bars minimum so i put the motor out and will change pistons' rings and motor seals.

Bild

Bild

Bild

rust in the cylinder :shock: :shock: :shock: i don't have put correctly the pistons' rings the first time.

Bild

i've made a cool picture of my garage 8) 8)

Bild

when the 319 will be finished, i'll attack the w110 :roll: 8)
we can't make new with old .... but we try 8)

Benutzeravatar
Compay
Beiträge: 948
Registriert: 24.08.2004, 11:44
Wohnort: holland

Re: [restoration] L319D - 1958

Beitragvon Compay » 08.09.2020, 12:59

le garage est superbe!

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 10.10.2020, 08:32

i got all the seal to rebuild again the motor

Bild

but one of the pistons rings is not the good one and broke when we mount it, not the good form :Wandhauer: :Wandhauer: :Wandhauer:

i command new today ..... have to wait, i can't do anything to rebuilt the motor without mounting the pistons ..... i'm starting to hate this OM636 :mrgreen:

instead of that, i started to dismantle the w110 and they are LOooooooooooooOOOOooooots of work :crazy: :crazy: bad repair by the past and the rust destroyed everything ....

Bild

Bild

and the same day , an old man of where i've my garage come in , (i'm not a professionnal , it's just a hangar i bought to put everybody in and work on during my free time ;) ) , he said to me he have an old mercedes he would like to sell to me , so now i wait the TüV OK and then buy it as a new daily ! :D :D it's a mercedes w123 200T from 1983

Bild
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 01.01.2021, 09:29

happy new year everybody ! wish the best to all for 2021 !

i'm finally in holidays for one week and now i can go to my garage to finish the L319 ! until now i can't go because of restriction due to the coronavirus. :cry:

otherwise my new car runs well ! just have the hydro-suspension to check ! i remade the brakes and cooling system + changing all the oil

Bild

Bild

i love this ass :klatsch: :klatsch: :lol:

Bild
we can't make new with old .... but we try 8)

Benutzeravatar
panzerjim
Beiträge: 222
Registriert: 19.04.2015, 07:14
Wohnort: Bretagne (France)
Kontaktdaten:

Re: [restoration] L319D - 1958

Beitragvon panzerjim » 28.03.2021, 18:54

sorry for not coming often but many work at these times.

good news ! on the road again ! :klatsch: :klatsch: :klatsch: still smoking a little and not enought torque when it climb, i'm searching a diesel professionnal to control why but now it runs !



Bild

Bild
we can't make new with old .... but we try 8)


Antworten

Zurück zu „Restaurierungsdokumentationen und Reparaturanleitungen“

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 5 Gäste